Begin with the issued order
On Northline Depot sheet E-301, the original count is six type A, three type B and one type C. Record that mix before opening issue B. An order of ten gives you a control total, but it gives you no way to identify a substitution.
| After checking | Type A | Type B | Type C |
|---|---|---|---|
| Original issue | 6 | 3 | 1 |
| Two storage-bay substitutions | 4 | 5 | 1 |
| Dock substitution included | 4 | 4 | 2 |
Walk the plan by room
Two storage-bay fixtures, WH-103 and WH-106, both change from A to B. Stop there and your draft revised order reads four A, five B and one C. It still adds to ten. That intermediate result is exactly why a balancing total makes a poor stopping rule.
Move across the partition to the loading dock. WH-201 changes from B to C. Its original B was already included in your starting order, so take one out of the B column before adding one to C. The final order reads four A, four B and two C.
Write a change note someone else can check
A second reader should be able to reproduce each adjustment without knowing how you counted. “Lights revised” tells them very little. “WH-103 and WH-106: A to B in storage; WH-201: B to C at dock” gives them locations and a short audit trail.
Finally, compare the net change for B with the actual work on the drawing. B rises by just one unit even though three substitutions affect that column. The net makes an efficient order adjustment. The three tags explain why it is right.
Check your understandingWhy does type B rise by only one?
Two storage locations gain B fixtures and the loading dock loses one. Two incoming minus one outgoing gives a net increase of one.